Verification of Coordinate Measuring Machine Using a Gauge Block
By: Teodor Tóth, Miroslav Dovica, Ján Buša and Ján Buša
Abstract
Two orthogonal least squares methods of the points approximation by a set of parallel planes are presented. Such an approximation can be used to study the measurement details of using a coordinate measuring machine (CMM). A calibrated gauge block and a CMM with a touch measuring probe were used in the experimental verification. A comparison of the different CMM strategies is provided.
DOI: https://doi.org/10.2478/msr-2024-0030 | Journal eISSN: 1335-8871
Language: English
Page range: 226 - 233
Submitted on: May 31, 2024
Accepted on: Nov 20, 2024
Published on: Dec 24, 2024
In partnership with: Paradigm Publishing Services
Publication frequency: Volume open
Keywords:
Related subjects:
© 2024 Teodor Tóth, Miroslav Dovica, Ján Buša, Ján Buša, published by Slovak Academy of Sciences, Institute of Measurement Science
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.