Effects of Epoxy-Coated Glass Fibers on the Mechanical Properties of Concrete
Abstract
Glass fibers are widely used in concrete mixtures; however, the highly alkaline environment of concrete degrades the properties of unprotected glass fibers. To address this issue, this study investigates the impact of coating glass fibers on the mechanical properties of concrete mixtures. The glass fibers were introduced in three forms: uncoated glass fibers, epoxy-coated glass fibers, or epoxy-coated and sand-coated glass fibers. The glass fiber percentages were 0%, 0.33%, 0.66%, or 1.0% by volume of the concrete mixture. The microstructural characterization of the interfacial transition zone between glass fibers and concrete was studied using SEM analysis. The mechanical properties of concrete mixtures were evaluated through the compressive strength, flexural, splitting, and tensile strength tests. Microstructural characterization using SEM confirmed that continuous epoxy encapsulation shields glass filaments from hydroxyl (OH-) ion ingress and alkaline etching. Surface sand treatment established mechanical keying with the matrix, densifying the interfacial transition zone (ITZ) with tightly packed C-S-H gel and shifting the failure mode from interfacial slip to matrix shear. In addition, the mechanical strength testing demonstrated compressive strength gains across all fiber types relative to the control mixture (without glass fiber). Although epoxy-coated glass fiber strands caused a minor compressive strength reduction at higher volume fractions due to the smooth surface (low surface friction), applying surface sand treatment restored interfacial friction and achieved a statistically significant 5.0% strength increase over smooth strands. Concrete mixtures incorporating epoxy-coated and sand-coated glass fiber strands exhibited superior performance, achieving maximum flexural and splitting tensile strength increases of 103.5% and 139.0%, respectively. Direct tension testing showed a 35.0% strength increase for epoxy-coated and sand-coated glass fiber strands due to enhanced interfacial shear transfer, which eliminated strand pull-out slip and forced tensile failure to occur within the concrete matrix.
© 2026 Khalid A. Abdullah, Ali Abdul Baki, Mohammed Ghanim Jamel, published by University of Žilina
This work is licensed under the Creative Commons Attribution 4.0 License.
