Experimental and Finite Element Investigation of Reinforced Concrete Corbels Strengthened with CFRP, Steel Plates, and Cementitious Repair Mortar
Abstract
This study investigates the effectiveness of seven strengthening methods for reinforced concrete corbels through experimental testing and nonlinear finite element analysis. Eight reinforced concrete corbels were cast and tested, including one control specimen and seven strengthened specimens incorporating CFRP, steel plates, steel strips, and Sika Mono-Top 612 in different configurations. The experimental results showed that the corbel strengthened with a 20 mm layer of Sika Mono-Top 612 achieved the highest increase in ultimate load, approximately 66% greater than the control specimen, and increased energy absorption by 224%. The corbel strengthened with a 3 mm steel plate covering the entire corbel face exhibited the greatest improvement in ductility, with a 70% increase compared with the control specimen. Although full CFRP strengthening increased the ultimate load by approximately 42%, its main benefit was the improvement in initial stiffness, which increased by approximately 70%. A nonlinear finite element model was developed to simulate the behaviour of the tested corbels, including their load-displacement response, ultimate capacity, stiffness, and failure behaviour. The model predicted the ultimate loads with an error of less than 10% compared with the experimental results. However, the initial stiffness was generally overestimated, mainly because of the idealized bond and boundary conditions adopted in the numerical model.
© 2026 Dolfocar Witwit, Maytham Khalid Gatea, Mohammed F. Ojaimi, Hayder Kadhem Adai Al-Farttoosi, published by University of Žilina
This work is licensed under the Creative Commons Attribution 4.0 License.
