Abstract
In the current work, a filtering scheme for measurement of area and perimeter of heat affected zone (HAZ) in welding has been proposed along with identification of defects like porosity in the fusion zone. A filtering scheme based on wavelet filtering, edge detection and morphology has been designed and implemented on a welding image for this purpose. To see the effectiveness of the wavelet based proposed filtering scheme, SNR is calculated and compared with the filtered image processed without wavelet denoising. Experimental results revel that the SNR improves by 45-65% when wavelet filtering is introduced in the filtering scheme. Crisscrosses of the boundary of HAZ were observed and compared. The wavelet based proposed filtering scheme enhances the HAZ boundary smoothness by 12.5% in comparison to the filtering scheme without using wavelet denoising. In the limiting case, for poor quality image of weldment, the deviation in measurement of HAZ by manual and proposed scheme is within 10%. Error in manual evaluation significantly contributes in the above deviation as the HAZ on the base metal side in the raw image is diffused and difficult to measure accurately.