Phase Change Heat Exchangers Made of Pin-Fins for Boiling Enhancement

Orman, Łukasz J.; Radek, Norbert; Pietraszek, Jacek; Gontarski, Dariusz

doi:10.2478/cqpi-2019-0059

Abstract

The paper deals with the important issue of boiling heat transfer enhancement using mechanical treatment of the heater surface. The surface has been modified in such a way that microfins have been produced. The application of such a structure leads to highly increased heat fluxes in relation to the smooth surface as has been presented and discussed in the paper. The experiments including distilled water and ethyl alcohol on the horizontal copper samples of 3 cm diameter have been considered. The heat flux value of microfinned surface was even nine times higher than the heat flux dissipated from the smooth surface without any coating. It proves a considerable enhancement of boiling with the application of the mechanically treated surfaces of heat exchangers.

References

Bara, M., Kmita, T., Korzekwa, J., 2016. Microstructure and properties of composite coatings obtained on aluminium alloys. Arch. Metall. Mater., 61, 1107-1112. DOI: 10.1515/amm-2016-023810.1515/amm-2016-0238
Open DOI Search in Google Scholar Back to article
Čaja, A., Nemec, P., Malcho, M., 2014. Influence of the ambient temperature during heat pipe manufacturing on its function and heat transport ability, EPJ Web of Conferences, 67, art. 02012, DOI: 10.1051/epjconf/20146702012.10.1051/epjconf/20146702012
Open DOI Search in Google Scholar Back to article
Domagala, M., Momeni, H., Domagala-Fabis, J., Filo, G., Krawczyk, M., 2018a. Simulation of Cavitation Erosion in a Hydraulic Valve. Materials Research Proceedings, 5, 1-6. DOI: 10.21741/9781945291814-110.21741/9781945291814-1
Open DOI Search in Google Scholar Back to article
Domagala, M., Momeni, H., Domagala-Fabis, J., Filo, G., Kwiatkowski, D., 2018b. Simulation of Particle Erosion in a Hydraulic Valve. Materials Research Proceedings, 5, 17-24. DOI: 10.21741/9781945291814-410.21741/9781945291814-4
Open DOI Search in Google Scholar Back to article
Dwornicka, R., 2014. The Impact of the Power Plant Unit Start-Up Scheme on the Pollution Load. Advanced Materials Research, 874, 63-69. DOI: 10.4028/www.scientific.net/AMR.874.6310.4028/www.scientific.net/AMR.874.63
Open DOI Search in Google Scholar Back to article
Fabis-Domagala, J., Filo, G., Momeni, H., Domagala, M., 2018. Instruments of identification of hydraulic components potential failures. MATEC Web Conf., 183, art. 03008. DOI: 10.1051/matecconf/20181830300810.1051/matecconf/201818303008
Open DOI Search in Google Scholar Back to article
Filo, G., Fabis-Domagala, J., Domagala, M., Lisowski, E., Momeni, H., 2018a. The idea of fuzzy logic usage in a sheet-based FMEA analysis of mechanical systems. MATEC Web Conf., 183, art. 03009. DOI: 10.1051/matecconf/20181830300910.1051/matecconf/201818303009
Open DOI Search in Google Scholar Back to article
Filo, G., Lisowski, E., Domagala, M., Fabis-Domagala, J., Momeni, H., 2018b. Modelling of pressure pulse generator with the use of a flow control valve and a fuzzy logic controller. AIP Conf. Proc., 2029, art. 020015. DOI: 10.1063/1.506647710.1063/1.5066477
Open DOI Search in Google Scholar Back to article
Gadek-Moszczak, A., Radek, N., Wronski, S., Tarasiuk, J., 2014. Application the 3D image analysis techniques for assessment the quality of material surface layer before and after laser treatment. Adv. Mat. Res. Switz., 874, 133-138. DOI: 10.4028/www.scientific.net/AMR.874.13310.4028/www.scientific.net/AMR.874.133
Open DOI Search in Google Scholar Back to article
Gadek-Moszczak, A., Wojnar, L. 2009. Objective, quantitative and automatic x-ray image analysis of the bone regenerate in the ilizarov method. ECS10: The 10th European Congress of Stereology and Image Analysis, Milan, Int. Society for Stereology, 453-458.
Search in Google Scholar Back to article
Gawlik, J., Kielbus, A., Karpisz, D., 2015. Application of an integrated database system for processing difficult material. Solid State Phenomena, 223, 35-45. DOI: 10.4028/www.scientific.net/SSP.223.3510.4028/www.scientific.net/SSP.223.35
Open DOI Search in Google Scholar Back to article
Hosseini, R., Gholaminejad, A., Jahandar, H., 2011. Roughness effects on nucleate pool boiling of R-113 on horizontal circular copper surfaces, World Academy of Science, Engineering and Technology, 55, 679-684. DOI: 10.5281/zenodo.107806810.5281/zenodo.1078068
Open DOI Search in Google Scholar Back to article
Karpisz, D., Kielbus, A., 2018. Selected problems of designing modern industrial databases. MATEC Web Conf., 183, art. 01017. DOI: 10.1051/matecconf/20181830101710.1051/matecconf/201818301017
Open DOI Search in Google Scholar Back to article
Kmita, T., Bara, M., 2012. Surface oxide layers with an increased carbon content for applications in oil-less tribological systems. Chemical and Process Engineering-Inzynieria Chemiczna i Procesowa, 33, 479-486. DOI: 10.2478/v10176-012-0040-z10.2478/v10176-012-0040-z
Open DOI Search in Google Scholar Back to article
Kozien, E., Kozien, M.S., 2017. Academic governance as a determinant of efficient management of a university in Poland - legal and comparative perspective. ESD 2017: Economic and Social Development Conf., Madrid, Varazdin, 38-47.
Search in Google Scholar Back to article
Krawczyk, J., Sobczyk, A., 2018. Tests of New Methods of Manufacturing Elements for Water Hydraulics. Materials Research Proceedings, 5, 200-205. DOI: 10.21741/9781945291814-3510.21741/9781945291814-35
Open DOI Search in Google Scholar Back to article
Lipinski, T., 2015. Double modification of AlSi9Mg alloy with boron, titanium and strontium. Arch. Metall. Mater., 60, 2415-2419. DOI: 10.1515/amm-2015-039410.1515/amm-2015-0394
Open DOI Search in Google Scholar Back to article
Maciejewska, B., Piasecka, M., 2017. Trefftz function-based thermal solution of inverse problem in unsteady-state flow boiling heat transfer in a minichannel, International Journal of Heat and Mass Transfer, 107, 925-933, DOI: 10.1016/j.ijheatmasstransfer.2016.11.003.10.1016/j.ijheatmasstransfer.2016.11.003
Open DOI Search in Google Scholar Back to article
Maciejewska, B., Piasecka, M., 2017. An application of the non-continuous Trefftz method to the determination of heat transfer coefficient for flow boiling in a minichannel, Heat and Mass Transfer, 53(4), 1211-1224, DOI: 10.1007/s00231-016-1895-1.10.1007/s00231-016-1895-1
Open DOI Search in Google Scholar Back to article
Nemec, P., Caja, A., Lenhard, R., 2009. Analysis of heat transfer limitation of wick heat pipe, Int. Conf. Experimental Fluid Mechanics 2009, Liberec, Czech Republic, 229-234.
Search in Google Scholar Back to article
Nemec, P., Malcho, M., Kaduchova, K., 2017. Experimental measurement, calculation and thermal visualization condenser temperature of cooling device with a heat pipe technology, EPJ Web of Conferences, 143, DOI: 10.1051/epjconf/201714302078.10.1051/epjconf/201714302078
Open DOI Search in Google Scholar Back to article
Nishikawa K., Fujita Y., Ohta H., Hidaka S., 1982. Effect of the surface roughness on the nucleate boiling heat transfer over the wide range of pressure, International Heat Transfer Conference, Munchen, Germany, 4, PB10, 61-66.10.1615/IHTC7.3790
Search in Google Scholar Back to article
Opydo, M., Kobylecki, R., Dudek, A., Bis, Z. 2016. The effect of biomass co-combustion in a CFB boiler on solids accumulation on surfaces of P91 steel tube samples. Biomass & Bioenergy, 85, 61-68. DOI: 10.1016/j.biombioe.2015.12.01110.1016/j.biombioe.2015.12.011
Open DOI Search in Google Scholar Back to article
Orman, Ł.J., 2013. Boiling heat transfer on single phosphor bronze and copper mesh microstructures, Int. Conf. Experimental Fluid Mechanics 2013, Kutná Hora, Czech Republic, 519-522. DOI: 10.1051/epjconf/2014670208710.1051/epjconf/20146702087
Open DOI Search in Google Scholar Back to article
Orman, Ł. J., 2016. Enhancement of pool boiling heat transfer with pin-fin microstructures, Journal of Enhanced Heat Transfer, 23, 137-153, DOI: 10.1615/JEnhHeatTransf.2017019452.10.1615/JEnhHeatTransf.2017019452
Open DOI Search in Google Scholar Back to article
Passos, J. C., Reinaldo, R.F., 2000, Analysis of pool boiling within smooth and grooved tubes, Experimental Thermal and Fluid Science, 22, 35-44, DOI: 10.1016/S0894-1777(00)00008-X.10.1016/S0894-1777(00)00008-X
Open DOI Search in Google Scholar Back to article
Pastuszko, R., 2018. Pool boiling heat transfer on micro-fins with wire mesh Experiments and heat flux prediction, International Journal of Thermal Sciences, 125, 197-209, DOI: 10.1016/j.ijthermalsci.2017.11.019.10.1016/j.ijthermalsci.2017.11.019
Open DOI Search in Google Scholar Back to article
Pastuszko, R., 2010. Pool boiling on micro-fin array with mesh structures, International Journal of Thermal Sciences, 49, 2289–2298, DOI: 10.1016/j.ijthermalsci.2010.07.016.10.1016/j.ijthermalsci.2010.07.016
Open DOI Search in Google Scholar Back to article
Pastuszko, R., Wójcik, T. M., 2015. Experimental investigations and a simplified model for pool boiling on micro-fins with sintered perforated foil, Experimental Thermal and Fluid Science, 63, 34-44, DOI: 10.1016/j.expthermflusci.2015.01.002.10.1016/j.expthermflusci.2015.01.002
Open DOI Search in Google Scholar Back to article
Ribatski, G., Saiz Jabardo, J. M., 2003. Experimental study of nucleate boiling of halocarbon refrigerants on cylindrical surfaces, International Journal of Heat and Mass Transfer, 46(23), 4439-4451, DOI: 10.1016/S0017-9310(03)00252-7.10.1016/S0017-9310(03)00252-7
Open DOI Search in Google Scholar Back to article
Skrzypczak-Pietraszek, E., Reiss, K., Zmudzki, P., Pietraszek, J., 2018. Enhanced accumulation of harpagide and 8-O-acetyl-harpagide in Melittis melissophyllum L. agitated shoot cultures analyzed by UPLC-MS/MS. PLoS ONE 2018, 13, art. e0202556. DOI: 10.1371/journal.pone.020255610.1371/journal.pone.020255610.1371/journal.pone.0202556
Search in Google Scholar Back to article
Strąk, K., Piasecka, M., Maciejewska, B., 2018. Spatial orientation as a factor in flow boiling heat transfer of cooling liquids in enhanced surface minichannels, International Journal of Heat and Mass Transfer, 117, 375-387, DOI: 10.1016/j.ijheatmasstransfer.2017.10.019.10.1016/j.ijheatmasstransfer.2017.10.019
Open DOI Search in Google Scholar Back to article

Phase Change Heat Exchangers Made of Pin-Fins for Boiling Enhancement

Abstract

Paradigm

My account