Acoustic Emission Control of Compounds with Interference, Which Are Assembled by Thermal Method

Zenkin, Mykola; Lisovets, Serhii; Makatora, Dmytro; Kosiba, Ján

doi:10.2478/ata-2025-0023

Abstract

Acoustic emission control means for tension connections are proposed. The features of the contact zone, such as the gas gap between the shaft and the bushing and the penetration of microroughnesses of the shaft surface into the bushing surface, are considered. It is shown that the main indicator of such compounds is total acoustic emission. It has been established that with increasing tension, the maximum intensity of acoustic emission signals is observed earlier, and their amplitude becomes larger. In addition, it has been found that total acoustic emission depends on the strength of joints and the magnitude of total acoustic emission can determine this strength. The paper presents the results of studies of several series of experimental and field samples. It has been established that the greater the intensity of acoustic emission signals and the lower the total acoustic emission, the stronger the tension bonds. It has been established that there is no direct relationship between the intensity of acoustic emission signals and the contact surface area, but with an increase in the contact area, total acoustic emission also increases.

References

AGLETDINOV, E. – POMPONI, E. – MERSON, D. – VINOGRADOV, A. 2016. A novel Bayesian approach to acoustic emission data analysis. In Ultrasonics, no. 72, pp. 89–94. DOI: https://doi.org/10.1016/j.ultras.2016.07.014
Search in Google Scholar Back to article
ALSHORMAN, O. – ALKAHATNI, F. – MASADEH, M. – IRFAN, M. – GLOWACZ, A. – ALHOBIANI, F. – KOZIK, J. – GLOWACZ, W. 2021. Sounds and acoustic emission-based early fault diagnosis of induction motor: A review study. In Advances in Mechanical Engineering, vol. 13, no. 2. DOI: https://doi.org/10.1177/1687814021996915
Search in Google Scholar Back to article
BAGHERI, A. – TARIGHI, J. – EMAMI, N. – SZYMANEK, M. 2024. Extension experts´ intentions to use precision agricultural technologies, a test with the technology acceptance model. In Acta Technologica Agriculturae, vol. 27, no. 2, pp. 84–91. DOI: https://doi.org/10.2478/ata-2024-0012
Search in Google Scholar Back to article
BARAT, V. A. – CHERNOV, D. V. – ELIZAROV, S. V. 2016. Discovering data flow discords for enhancing noise immunity of acoustic-emission testing. In Russian Journal of Nondestructive Testing, vol. 52, no. 6, pp. 347–356. DOI: https://doi.org/10.1134/S1061830916060024
Search in Google Scholar Back to article
BERANEK, L. – MELLOW, T. 2019. Acoustics: Sound Fields, Transducers and Vibration. UK : Elsevier, Academic Press, 900 pp. ISBN 978-0-12-815227-0. DOI: https://doi.org/10.1016/C2017-0-01630-0
Search in Google Scholar Back to article
BERTAGNOLIO, F. – MADSEN, H. A. – FISCHER, A. – BAK, CH. 2017. A semi-empirical airfoil stall noise model based on surface pressure measurements. In Journal of Sound and Vibration, vol. 387, pp. 127–162. DOI: https://doi.org/10.1016/j.jsv.2016.09.033
Search in Google Scholar Back to article
BUILO, S. I. 2013. Physical, mechanical and statistical aspects of acoustic emission diagnostics. In Physics and Mechanics of New Materials and Their Applications. New York : Nova Science Publishers, no. 15, pp. 171–184.
Search in Google Scholar Back to article
DANYUK, A. – MERSON, D. – VINOGRADOV, A. 2014. New prospects to use acoustic emission during scratch testing for probing fundamental mechanisms of plastic deformation. In The 12^th International Conference of the Slovenian Society for Non-Destructive Testing “Application of Contemporary Non-Destructive Testing in Engineering”, 4–6 September 2013, Portorož, Slovenia, pp. 567–574.
Search in Google Scholar Back to article
DANYUK, A. V. – RASTEGAEV, I. A. – MERSON, D. L. – VINOGRADOV, A. 2017. Advanced-reliability acoustic-emission transducers. In Russian Journal of Nondestructive Testing, vol. 53, no. 1, pp. 32–38.
Search in Google Scholar Back to article
CHAN, P. K. – STOLFO, S. J. 1998. Toward scalable learning with nonuniform class and cost distributions: A case study in credit card fraud detection. In KDD´98 Proceedings of the 4^th International Conference on Knowledge Discovery and Data Mining, New York, USA, 27–31 August 1998, pp. 164–168.
Search in Google Scholar Back to article
GLOWACZ, A. 2018. Acoustic based fault diagnosis of three-phase induction motor. In Applied Acoustics, vol. 137, pp. 82–89. DOI: https://doi.org/10.1016/j.apacoust.2018.03.010
Search in Google Scholar Back to article
JIANG, C. – SONG, Q. – GUO, D. – LI, H. 2014. Estimation algorithm of minimum dwell time in precision cylindrical plunge grinding using acoustic emission signal. In International Journal of Precision Engineering and Manufacturing, vol. 15, pp. 601–607. DOI: https://doi.org/10.1007/s12541-014-0377-y
Search in Google Scholar Back to article
KOVACEVIC, R. – MOMBER, A. W. – MOHEN, R. S. 2002. Energy dissipation control in hydro-abrasive machining using quantitative acoustic emission. In The International Journal of Advanced Manufacturing Technology, vol. 20, no. 6, pp. 397–406. DOI: https://doi.org/10.1007/s001700200169
Search in Google Scholar Back to article
LACAGNINA, G. – CHAITANYA, P. – KIM, J.-H. – BERK, T. – JOSEPH, P. – CHOI, K.-S. GANAPATHISUBRAMANI, B. – HASHEMINEJAD, S. M. – CHONG, T. P. – STALNOV, O. SHAHAB, M. F. – OMIDYEGANEH, M. – PINELLI. A. 2021. Leading edge serrations for the reduction of aerofoil self-noise at low angle of attack, pre-stall and post-stall conditions. In International Journal of Aeroacoustics, vol. 20, no. 1–2, pp. 130–156. DOI: https://doi.org/10.1177/1475472X20978379
Search in Google Scholar Back to article
LIU, J. – JIANG, C. – YANG, X. – SUN, S. 2024. Review of the application of acoustic emission technology in green manufacturing. In International Journal of Precision Engineering and Manufacturing-Green Technology, vol. 11, no. 3, pp. 995–1016. DOI: https://doi.org/10.1007/s40684-023-00557-w
Search in Google Scholar Back to article
NARAYANAN, S. – SINGH, S. K. – KANT, M. – NARAYANMURTHY, A. 2024. Control of fan broadband noise through wavy leading and trailing edge serrations. In International Journal of Aeroacoustics, vol. 24, no. 1–2, pp. 90–103. DOI: https://doi.org/10.1177/1475472X241306316
Search in Google Scholar Back to article
NASHED, M. S. – STEEL, J. A. – REUBEN, R. L. 2013. The use of acoustic emission for the condition assessment of gas turbines: Acoustic emission generation from normal running. In Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, vol. 228, no. 4, pp. 286–308. DOI: https://doi.org/10.1177/0954408913502167
Search in Google Scholar Back to article
O´BRIEN, R. J. – FONTANA, J. M. – PONSO, N. – MOLISANI, L. 2017. A pattern recognition system based on acoustic signals for fault detection on composite materials. In European Journal of Mechanics – A/Solids, vol. 64, pp. 1–10. DOI: https://doi.org/10.1016/j.euromechsol.2017.01.007
Search in Google Scholar Back to article
OHTSU, M. 2015. Acoustic Emission (AE) and Related Nondestructive Evaluation (NDE) Techniques in the Fracture Mechanics of Concrete. Fundamentals and Applications. UK : Elsevier, Woodhead Publishing, 318 рp. ISBN 978-1-78242-327-0. DOI: https://doi.org/10.1016/C2014-0-02667-6
Search in Google Scholar Back to article
POMPONI, E. – VINOGRADOV, A. – DANYUK, A. 2015. Wavelet based approach to signal activity detection and phase picking: Application to acoustic emission. In Signal Processing, no. 115, pp. 110–119. DOI: https://doi.org/10.1016/j.sigpro.2015.03.016
Search in Google Scholar Back to article
POMPONI, E. – VINOGRADOV, A. 2013. A real-time approach to acoustic emission clustering. In Mechanical Systems and Signal Processing, vol. 40, no. 2, pp. 791–804. DOI: https://doi.org/10.1016/j.ymssp.2013.03.017
Search in Google Scholar Back to article
RANI, M. – DHOK, S. – DESHMUKH, R. 2020. A machine condition monitoring framework using compressed signal processing. In Sensors, vol. 20, no. 1, article no. 319. DOI: https://doi.org/10.3390/s20010319
Search in Google Scholar Back to article
SHAO, H. – JIANG, H. – LI, X. – WU, S. 2018. Intelligent fault diagnosis of rolling bearing using deep wavelet auto-encoder with extreme learning machine. In Knowledge-Based Systems, vol. 140, pp. 1–14. DOI: https://doi.org/10.1016/j.knosys.2017.10.024
Search in Google Scholar Back to article
ZHANG, Y. – WANG, T. – PAN, W.-P. – ROMERO, C. E. 2019a. Advances in Ultra-Low Emission Control Technologies for Coal-Fired Power Plants. UK : Elsevier, Woodhead Publishing, 273 рp. ISBN 978-0-08-102418-8. DOI: https://doi.org/10.1016/C2017-0-00932-1
Search in Google Scholar Back to article
ZHANG, J. – YANG, S. – HAO, R. – GU, X. 2019b. Amplitude attenuation laws of acoustic emission waves in plate structures. In Dyna, vol. 94, no. 1, pp. 67–74. DOI: http://dx.doi.org/10.6036/8987
Search in Google Scholar Back to article
ZHAO, X. – JIA, M. – LIN, M. 2020. Deep Laplacian Auto-encoder and its application into imbalanced fault diagnosis of rotating machinery. In Measurement, vol. 152, article no. 107320. DOI: https://doi.org/10.1016/j.measurement.2019.107320
Search in Google Scholar Back to article
ŽITŇÁK, M. – LENDELOVÁ, J. – PIVARČIOVÁ, Z. – KORENKO, M. – KIEŁBASA, P. – DOSTÁL, P. 2023. Possibilties of noise load elemination in production. In Acta Technologica Agriculturae, vol. 26, no. 1, pp. 42–48. DOI: https://doi.org/10.2478/ata-2023-0006
Search in Google Scholar Back to article
WANG, W.-J. – CUI, L.-L. – CHEN, D.-Y. 2016. Multi-scale morphology analysis of acoustic emission signal and quantitative diagnosis for bearing fault. In Acta Mechanica Sinica, vol. 32, pp. 265–272. DOI: https://doi.org/10.1007/s10409-015-0529-z
Search in Google Scholar Back to article
WU, Z. – GUO, Y. – LIN, W. – YU, S. – JI, Y. 2018. A weighted deep representation learning model for imbalanced fault diagnosis in cyber-physical systems. In Sensors, vol. 18, no. 4, article no. 1096. DOI: https://doi.org/10.3390/s18041096
Search in Google Scholar Back to article
XU, B. – WU, J. – WANG, M. 2017. Study of modal acoustic emission to monitor the impact damage in a composite plate. In Journal of Vibroengineering, vol. 19, no. 5, pp. 3335–3348. DOI: https://doi.org/10.21595/jve.2017.17879
Search in Google Scholar Back to article

Acoustic Emission Control of Compounds with Interference, Which Are Assembled by Thermal Method

Abstract

Paradigm

My account