Abstract
This work describes a specially developed software for controllable magnetic hysteresis measurements of amorphous and nanocrystalline ribbons. The sophisticated algorithm enables to simplify a hardware design and to suppress an influence of experimental conditions on the measurement results. The main software feature is a three-stage feedback algorithm, which accurately adjusts the magnetization conditions: magnetization amplitude, geomagnetic bias and magnetization waveform. Air flux compensation of the induction signal is also performed by the software using an effective value of the coil cross section obtained from a calibration measurement without the ribbon. Applicability of the designed setup is illustrated for a series of nanocrystalline Hitperm ribbons measured at the power-line conditions: 50 Hz frequency and sinusoidal magnetization waveform.