References
- Afrose M.F., Masood S.H., Iovenitti P., Nikzad M., Sbarski I., Effects of part build orientations on fatigue behaviour of FDM-processed PLA material, Prog. Addit. Manuf., 1(1-2), 21-28, (2016).
- Bogue R., 3D printing: the dawn of a new era in manufacturing? Assembly Autom., 33(4), 307-311, (2013).
- Chitariu D., Munteanu A., Research on 3D printed fixture components, MATEC Web of Conferences 178, 02008, (2018)
- Ciorap M., Andrițoi A., Dumitraș C., Ciorap R., Low-cost wearable knee joint angle measurements system manufacturing using industry 4.0 concept, the XXVII international conference “inventica 2023. Science of creativity”, iunie 2023, pag 115-121, DOI 10.2478/9788367405201-011.
- Gibson I., Rosen D.W., Stucker B., Additive Manufacturing Technologies: 3D Printing, Rapid Prototyping, and Direct Digital Manufacturing (2nd ed.), Springer, 2015.
- Huang Y., Liang Y., Zhang Y., Design and optimization of infill patterns in 3D printing, J. Mech. Des., 139(5), 051701, (2017).
- Jiang Q., Han Z., Luo J., Dong, J. Experimental analysis of additive manufacturing by fused deposition modeling considering replication accuracy and surface roughness, Materials, 10(12), 1300, (2017).
- Lee J., Nam J., Cho W., Evaluation of mechanical properties of 3D printed structures using grid infill patterns, Mater. Sci. Eng., 732, 138695, (2019).
- Lin D., Chai H., Du Z., A novel sparse in-fill pattern for fused deposition modeling, Polymers, 10(6), 632, (2018).
- Ning F., Cong W., Qiu J., Wei J., Wang S. Additive manufacturing of carbon fiber reinforced thermoplastic composites using fused deposition modeling: Effects of process parameters on tensile properties, J. Compos. Mater., 54(4), 447-457, (2020).
- Rouse J., Fractals and 3D printing: the impact of grid patterns on print efficiency and structural integrity, Adv. Manuf. Technol., 83(7), 1009-1017, (2017).
- Ventola C.L., Medical applications for 3D printing: current and projected uses, P&T, 39(10), 704-711, (2014).
- Zhang X., Chen L., Wei H., Optimizing 3D printing performance with advanced infill patterns, J. Addit. Manuf., 24, 114-126, (2018).
- Wu W., Geng P., Li G., Zhao D., Zhan H., Zhao J., Influence of layer thickness and raster angle on the mechanical properties of 3D-printed PEEK and a comparative mechanical analysis of PEEK and PLA, J. Mater. Res., 30(11), 1800-1806, (2015).