Abstract
Deterioration of treated drinking water intended for consumption during distribution may be due to physical, chemical or microbiological changes that occur in the water. In addition, the type of pipe material and disintegration of a disinfectant agent can affect the quality of the water supplied. Therefore, the research approach is to simulate the decay residual Cl2 through potable water distribution networks produced by a desalination plant of Oran city in western Algeria. EPANET 2.0 software was used for estimating and predicting Cl2 concentration at different water network points. The value of bulk flow decay coefficient (Kb) is set to −1,99 day−1 for a 50-year-old steel pipe, value for the wall decay coefficient (Kw) was determined using a trial-and-error procedure and assumed to be −1,2 day−1.
An efficient model with an extended simulations period of 72 h can plot spatial and temporal variations of residual Cl2 concentrations at all links and nodes. Cl2 is injected at the El Mactaa desalination plant, with a concentration of 0.6 mg/l permanently. As well, it was observed that 51.33% of the Cl2 loss is due to pipe wall reaction, while 42.34 and 6.33% represent the bulk and tank reactions respectively. The results show that the range of residual Cl2 (0.11-0,45 mg/l) and most of the measured values are less than are below the minimum authorized threshold (0.2 – 0.5 mg/l) WHO standard. Therefore, it is recommended to rehabilitate the old water transfer pipes and re-chlorination stations were necessary to add into network. Statistical analysis shows that the calculated results correspond well to the observed data. EPANET can follow the Cl2 concentration in the drinking water network produced by El Mactaa desalination plant. It is a research tool to improve our understanding of water movement in the distribution system.