Monitoring the Capability of Production Equipment in Organization
Abstract
This work is focused on determining the capability of production equipment in Volkswagen Slovakia, a.s. during the moulding of a car door. There were taken 150 samples from the moulding process that followed each other. Values were recorded on a Wenzel RAplus 1625 measuring machine. Subsequently, process stability was verified. It showed that measured values had a stable average value, and the process did not show irregularities in the diagrams of the X card and s card. After verification of stability, the values of Cm and Cmk were calculated, which exceeded the minimum requirement of 1.66 and 1.67, and the requirements for the capability of production equipment have thereby been met.
© 2014 Miroslav Prístavka, Marián Bujna, published by Slovak University of Agriculture in Nitra
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 3.0 License.