References
- J. A. Becker, C. B. Green, G. L. Pearson, “Properties and uses of thermistors thermally sensitive resistors”, Am. Inst. Elect. Eng. Trans., Vol. 65(11), pp 711-725, 1946.
- S. A. Kanade, V. Puri, “Composition dependent resistivity of thick film Ni(1-x) CoxMn2O4: (o≤x≤1) NTC thermistors”, Materials Letters , vol. 60, pp. 1428-1431, 2006.
- D. Houivet, J. Bernard, J. M. Haussonne, “High temperature NTC ceramic resistors (ambient-1000°C)”, J. European Ceram. Soc., vol. 24, pp.1237- 1241, 2004.
- A. Banerjee, S.A. Akbar, “A new method for fabrication of stable and reproducible yttria-based thermistors”, Sen. and Actuators, vol. 87, pp. 60- 66, 2000.
- G. Lavenuta, ‘Negative temperature coefficient thermistors” Sensors, vol.14, pp46-55 , 1997.
- J. G. Fagan, V. R. W. Amarkoon, “Reliability and reproducibility of ceramic sensors: Part I NTC thermistor” Am. Ceram. Soc, Bull. 72, pp70- 78, 1993.
- K. Park, S. J. Yun, “Effect of SiO2 addition on the electrical stability of (Mn2.1-xNi0.9Six)O4 (0≤x≤0.18) negative temperature coefficient thermistors”, Mater. Lett, vol. 58, pp933-937, 2004.
- B. Gillot, J. L Baudour, F. Bouree, etal., “Ionic configuration and cation distribution in cubic nickel manganite spinels NixMn3−xO4 (0.57
- K. Park, “Microstructure and electrical properties of Ni1.0Mn2−xZrxO4 (0≤x≤1.0) negative temperature coefficient thermistors “ Mater, Sci. Eng. B, vol 104, pp9-14, 2003.
- J. L. M. Vidales, P. Garcia-Chain, R. M. Rojas, E. Vila, O. Garcia- Martinez, “Preparation and characterization of spinel type Mn-Ni-Co-O negative temperature coefficient ceramic thermistors”, J. Mater. Sci., Vol. 33, pp1491-1496, 1998.
- R. N. Jadhav, V.Puri, “Influence of copper substitution on structural, electrical and dielectric properties of Ni(1-x) CuxMn2O4 (o≤x≤1) ceramics”, J. of Alloys and Compounds, vol.507, pp.151-156, 2010.
- R. N. Jadhav, S. N. Mathad, V. Puri, “ Sutudies on the porperties of Ni0.6Cu0.4Mn2O4 NTC ceramic due to Fe doping”, Ceram. International, vol.38, pp. 5181-5188, 2012.
- A. Feltz, W. Polzl, “Spinel forming ceramics of the system FexNiyMn3-x- yO4 for high temperature NTC thermistor applications”, J. Eur. Ceram. Soc., vol. 20, pp2353-2366, 2000.
- X. Li, Y. Luo, X. Li, “Preparation and electrical properties of perovskite ceramics in the system BaBi1−xSbxO3 (0 ≤ x ≤ 0.5)” J. of Alloys and compounds, vol. 509, pp.5373-5375, 2011.
- Y. Luo, X. Liu, “High temperature NTC BaTiO3-base ceramic resistors”, Mat. Letters, vol. 59, pp. 3881-3884, 2005.
- G. H. Jin, G. P. Choi, W. Y. Lee, and J. S. Park, “Gas Sensing Property of Perovskite SrTi1−xFexO3 Fabricated by Thick Film Planar Technology”, J. of Nanoscience and Nanotechnology, vol. 11, pp.1738–1741, 2011.
- W. Y. Lee, D. M. Na and J. S. Park, “Planar sensor properties of perovskite Sr(Ti1-xFex)O3-δ powders prepared by a sol gel Method” J. of Ceram. Processing Research. vol. 13(6), pp. 717-720, 2012.
- S. H. Choi, S. J. Choi, B. K. Min, W. Y. Lee, J. S. Park, I. D. Kim, “Facile Synthesis of p-type Perovskite SrTi0.65Fe0.35O3–d Nanofibers Prepared by Electrospinning and Their Oxygen-Sensing Properties”, Macromol. Mater. Eng., vol. 298(5), pp.521–527, 2013.
- G.Thornton, B.C.Tofield, D.E.Williams, “Spin state equilibria and the semiconductor to metal transition of LaCoO3”, Solid State Commun., vol.44, pp1213, 1982.
- K. Asai, A. Yokokura, J.M. Tranquada, etal., “Two spin-state transitions in LaCoO3”, J. Phys. Soc. Jpn., vol. 67, pp290, 1998.