Frequency Processing And Temperature-Pressure Compensation Of The Vortex Flowmeter Based On Two-Phase Flow
By:
References
- I. Scott and R.W.W, “Development in Flow Measurement”, Applied Science Pub, 1982, pp. 18-32.
- Yang Jianjun and Zhao Qingsheng, “Steam Flow Measurement of Temperature-pressure Compensation”, China Metrology, April 2011, pp. 94-95.
- Liu Sanshan, Xu Kejun, Zhu Zhihai, “Development of Differential Charge Amplifier for Vortex Flowmeter”, Automation & Instrumentation, Vol. 8, No. 5, November 2008, pp. 8-11.
- Bao Lisha, Liang Junting and Lu Jie, “Mathematic model of multi-path ultrasonic gas flowmeter”, Technical Acoustics, Vol. 29, No. 4, August 2010, pp. 392-395.
- N. Eidenberger and B.G. Zagar, “Capacitive Sensor Design Utilizing Conformal Mapping Methods”, INTERNATIONAL JOURNAL ON SMART SENSING AND INTELLIGENT SYSTEMS, Vol. 5, No. 1, March 2012, pp. 36-56.
- Sani Muhamad Isa, M. Eka Suryana, M. Ali Akbar, Ary Noviyanto, Wisnu Jatmiko and Aniati Murni Arymurthy, “Performance Analysis of ECG Signal Compression using SPIHT”, INTERNATIONAL JOURNAL ON SMART SENSING AND INTELLIGENT SYSTEMS, Vol. 6, No. 5, December 2013, pp. 2011-2039.
- Lu Jie and Liang Junting, “The research and calibration of small-caliber ultrasonic gas flowmeter”, Acoustics Technology, Vol. 22, No. 4, 2003, pp. 230-232.
- Mohd Fua’ad Rahmat and Teimour Tajdari, “Particles Mass Flow Rate and Concentration Measurement using Electrostatic Sensor”, INTERNATIONAL JOURNAL ON SMART SENSING AND INTELLIGENT SYSTEMS, Vol. 4, No. 2, June 2011, pp. 313-324.
- Amadi-Echendu, J.E. and Hingham, “Analysis of Signals from Vortex Flowmeter”, Flow Measurement and Instrumentation, Vol. 41, Issue. 6, August 1993, pp. 42-45.
- R.G. Kryshtal and A.V. Medved, “Single SH-Saw Sensor as A Distributed Sensor Array for Liquids Recognition”, INTERNATIONAL JOURNAL ON SMART SENSING AND INTELLIGENT SYSTEMS, Vol. 2, No. 4, December 2009, pp. 602-611.
- A. Lanevile, A. Strzelecki, P. Ganjan and P. Hebrard, “Signal qualify of a vortex flowmeter exposed to swirling flows”, Flow Measurement and Instrumentation, Vol. 4, No. 3, April 1993, pp. 151-154.
- Wang Zhimin and Wang Yichao, “Flow Check System with Compensation and Its Application”, Instruments and measurement and control, Vol. 24, No. 3, March 2002, pp. 26-28.
- Papagiannakis and K.Senn, “WIM system calibration using AVI-equipped vehicles”, Vehicle Navigation and Information Systems Conference, June 1995, pp. 299-304.
- Bernhard Menz, “Vortex flowmeter with enhanced accuracy and reliability by means of sensor fusion and self-validation”, Journal of the International Measurement Confederation, Vol. 22, No. 3, November 1998, pp. 123-128.
- Li Zigao, Liu Jia and Lu Hongming, “Configuration Approach Method for Realizing Steam Flux Measurement with Temperature and Pressure Compensation in DCS”, AUTOMATION IN PETRO-CHEMICAL INDUSTRY, Vol. 64, No. 4, February 2007, pp. 64-67.
- Dong Wang and Lin Zonghu, “Gas-liquid two-phase flow measurement using ESM”, Experimental Thermal and Fluid Science, Vol. 26, No. 6, August 2002, pp. 827-832.
- Sun Hongjun, Liu Zhongjie, Wang Linfang and Li Jinxia, “Research on the Installation Location of the Vortex Probe for Gas-liquid Two-phase Flow with Low Liquid Fraction”, JOURNAL OF MECHANICAL ENGINEERING, Vol. 50, No. 4, February 2014, pp. 167-171.
DOI: https://doi.org/10.21307/ijssis-2017-708 | Journal eISSN: 1178-5608
Language: English
Page range: 1326 - 1346
Submitted on: Mar 30, 2014
Accepted on: Sep 1, 2014
Published on: Sep 1, 2014
Published by: Professor Subhas Chandra Mukhopadhyay
In partnership with: Paradigm Publishing Services
Publication frequency: 1 issue per year
Keywords:
Related subjects:
© 2014 Zhang Haining, Ren Yonghui, published by Professor Subhas Chandra Mukhopadhyay
This work is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 License.