Liyun Fan, Bingqi Tian, Chong Yao, Wenhui Li and Xiuzhen Ma . “A Study on Cycle Fuel Injection Quantity Variation for a Diesel Engine Combination Electronic Unit Pump System”. Journal of Power and Energy, Proceedings of the Institute of Mechanical Engineers Part A, Vol 226, Issue: 5 (2012) pp. 712-723, 2012.
Jen-Hao Liu, Yu-Fan Chen, Tzu-Shiang Lin, Chia-Pang Chen, Po-Tang Chen, Tzai-Hung Wen, Chih-Hong Sun, Jehn-Yih Juang and Joe-Air Jiang. “An Air Quality Monitoring System for Urban Areas Based on the Technology of Wireless Sensor Networks”. International Journal of Smart Sensing and Intelligent Systems. Vol 5, No. 1, pp. 191-214, 2012.
Fan L. and Long W., Zhu Y. and Xue Y. “A Characteristic Study of Electronic In-line Pump System for Diesel Engines”. SAE Paper 2008-01-0943, 2008.10.4271/2008-01-0943
Liyun F., Yuanxian Z., Xiuzhen Ma, Bingqi T., Song E. and Li W. “Quantitative Analysis on Cycle Fuel Injection Quantity Fluctuation of Diesel Engine Electronic In-line Pump System”. SAE Paper 2010-01-0875, 2010.10.4271/2010-01-0875
C. D. Rakopoulos and D. T. Hountalas. “A Simulation Analysis of a DI Diesel Engine Fuel Injection System Fitted with a Constant Pressure Valve”. Energy Conversion and Management Vol. 37, No. 2, pp. 135-150, 1996.10.1016/0196-8904(95)00176-E
H-K Lee, M. F. Russell and C S Bae. “Mathematical Model of Diesel Fuel Injection Equipment Incorporating Non-Linear Fuel Injection”. Journal of Automobile Engineering, Proceedings of the Instn Mech Engrs Part D Vol 216, Issue: 3(2002-01) pp. 191-204, 2002.10.1243/0954407021529039
A. E. Catania, A. Ferrari, E. Spessa. “Temperature Variations in the Simulation of High- Pressure Injection-System Transient Flows under Cavitation”. International Journal of Heat and Mass Transfer 51 (2008) 2090-2107, 2008.
Kristina Ahlin. “Modelling of Pressure Waves in the Common Rail Diesel Injection System”. Dissertation 2000. www.fs.isy.liu.se/Publications/MSc/00_EX_3081_KA.pdf
Y. Nishidate and G. P. Nikishkov. “Fast water animation using the wave equation with damping”. ICCS 2005, LNCS 3515, pp. 232–239, 2005.10.1007/11428848_29
M. A. Rammaha. “The influence of damping and source terms on solutions of nonlinear wave equations”. Bol. Soc. Paran. Mat. (3s.), v. 25, 1-2 (2007), pp. 77-90, 2007.10.5269/bspm.v25i1-2.7427
Ryo Ikehata. “New decay estimates for linear damped wave equations and its application to nonlinear problem. Mathematical methods in the Applied Sciences”. Math. Meth. Appl. Sci. 2004; 27, pp. 865–889, 2004.10.1002/mma.476
Fariba Fahroo. “Optimizing the Decay Rate in the Damped Wave Equation: A Numerical Study”. Proceedings of the American Control Conference. pp. 2108-2113, 2003.
Jaime E. and Reinhard Racke. “Wave equations with non-dissipative damping”. Konstanzer Schriften in Mathematik und Informatik, Nr. 169, April 2002. ISSN 1430-3558, 2002.
Patrick Martinez. “Stabilization for the wave equation with Neumann boundary condition by a locally distributed damping”. ESAIM: Proceedings, Vol. 8, 2000, pp. 119-136, 2000.10.1051/proc:2000009
Oudina Assia and Djelouah Hakim. “Propagation of Ultrasonic Waves in Viscous Fluids”. Wave Propagation in Materials for Modern Applications. Andrey Petrin (Ed.), ISBN: 978-9537619-65-7, InTech, 2010.10.5772/6857
P. M. Jordan, Martin R. Meyer and Ashok Puri. “Causal implications of viscous damping in compressible fluid flows”. The American Physical Society, Physical Review E, Vol. 62, No. 6, pp. 7918 – 7926, 2000.
Reinhold Ludwig and Peter L. Levin. “Analytical and Numerical Treatment of Pulsed Wave Propagation into a Viscous Fluid”. IEEE Trans. On Ultrasonics, Ferroelectic. and Frequency Control. Vol.42, No.4, pp. 789-792, 1995.10.1109/58.393124
Alexander Thomann. “Introduction to PML in time domain”. Seminar for Applied Mathematics, Eidgenössische Technische Hochschule, Zürich, 2005. www.sam.math.ethz.ch/~hiptmair/Seminars/ABC/slides/thomann.pdf.
Boban D. Nikolic, Breda Kegl, Sasa D. Markovic and Melanija S. Mitrovic. “Determining the Speed of Sound, Density and Bulk Modulus of Rapeseed Oil, Biodiesel and Diesel Fuel”. Thermal Science, 2012, Vol. 16, Suppl. 2, pp. S569-S579, 2012.10.2298/TSCI120426187N
C. C. Enweremadu, H. L. Rutto and J. T. Oladeji “Investigation of the relationship between some basic flow properties of shea butter biodiesel and their blends with diesel fuel”. International Journal of Physical Sciences, Vol 6 (4). Pp. 758-767, 2011.
Marzena Dzida and Piotr Prusakiewicz. “The effect of temperature and pressure on the physicochemical properties of petroleum diesel oil and biodiesel fuel”. Fuel, 2008, 87, pp.1941194810.1016/j.fuel.2007.10.010
Andre’ L. Boehman, David Morris and James Szybist. “The Impact of the Bulk Modulus of Diesel Fuels on Fuel Injection Timing”. Energy & Fuels 2004, 18, pp. 1877-1882, 2004.
Mustafa E. Tat and Jon H. Van Gerpen. “Effect of Temperature and Pressure on the Speed of Sound and Isentropic Bulk Modulus of Mixtures of Biodiesel and Diesel Fuel”. JAOCS, 2003, 80(11), pp.1127-113010.1007/s11746-003-0830-x
Wang Jun-Xiao, Lu Jia-Xiang, Zhang Jin-Yang and Zhang Xi-Chao. “Study on Several Experiential Formulas Used in Simulated Calculation of Fuel Injection Process in Diesel Engines”. Vehicle Engine, 2001, Vol.5(135) pp.6-11, 2001.
D. N. Moriasi, J. G. Arnold, M. W. Van Liew, R. L. Bingner, R. D. Harmel and T. L. Veith. “Model Evaluation Guidelines for Systematic Quantification of Accuracy In Watershed Simulations”. Transactions of the ASABE. Vol 50, issue 3 pp. 885-900, 2007.10.13031/2013.23153
Qaisar Hayat, Fan Li-Yun, Xiu-Zhen Ma, Tian Bingqi, Naeim Farouk, Bai Yun and Xiu- Zhen Ma. “Mathematical Modeling of Fuel Pressure inside High Pressure Fuel Pipeline of Combination Electronic Unit Pump Fuel Injection System”. Accepted for publication in Research Journal of Applied Sciences, Engineering and Technology, 2013.
Qaisar Hayat, Fan Li-Yun, Xiu-Zhen Ma and Tian Bingqi. “Study of Effect of Key Fuel Properties on Pressure Wave Propagation Inside HP Fuel Pipeline of CEUP System”. (Submitted for publication, 2013).
Qaisar Hayat, Fan Li-yun, Xiu-Zhen Ma and Tian Bing-qi. “Comparison of three Mathematical Pressure Wave Models for HP Fuel Pipeline of CEUP”. (Submitted for publication, 2013).